Clamp Meter DCM660R SANWA

【Features】
True effective value measurement possible (AC).
Equipped with INRUSH (rush current) measurement function (within approximately 100ms, 10A~)
MAX/MIN hold function.
The liquid crystal display is equipped with a backlight.
Frequency measurement possible with clamps or test leads
Equipped with data hold function
Auto power save function that can be released after about 15 minutes

【Use】
For equipment maintenance.
For electrical work.

【Specification】
AC current (A): 660
DC voltage (V): 600
AC voltage (V): 600
Resistance (Ω): 660
Detection method: True RMS rectification (RMS)
Calibration documents: True RMS Value rectification (RMS)
Power source (V): AAA alkaline batteries (LR03) x 2 (included)
Width (mm): 69
Depth (mm): 38
Height (mm): 208
Power source: AAA Alkaline dry battery (LR03) x 2 (included) Continuity check: Buzzer sound at approx. 30Ω or less Open circuit voltage approx. 1.2V Frequency (Hz) Voltage: 100k Frequency (Hz) current: 30.00k Maximum measurement conductor diameter (mm) :φ50
Maximum display (count): 6600
Clamp diameter: 30mm

【Specification2】
Display count: 6600 counts
Width x depth x height (mm): 69x38x208
Battery life: 55 hours
Can measure up to AC660A

【Material/Finish】
－

【Set contents/accessories】
Instruction manual
Mobile case C-DCM-660
Test lead TL-23a

【caution】
This instrument is a clamp meter for low voltage. Do not use on electrical circuits where the voltage to ground exceeds 600V.
Do not switch to other functions during measurement.
Be sure to wear insulating protective equipment such as electrical rubber gloves when attaching or detaching to live conductors.
Do not input signals exceeding the maximum rated input value.
During measurement, do not hold the test probe on the test pin side or beyond the clamp sensor barrier.