Electric Driver 220USBP1 VESSEL

【Features】
Equipped with 3-stage rotation speed/torque switching mode.
Reinforced gear and body increase strength by 20% compared to conventional models.
Uses a USB type C connector so you don't have to worry about charging.
Equipped with a fall prevention cord attachment hole to prevent fall accidents.

【Use】
For electronic terminal block work, distribution board terminal work, tightening light screws and long screws, etc.

【Specification】
Maximum tightening torque (N・m): 1.2・1.6・2.0
Body dimensions (mm): 147
No-load rotation speed (min [[-1st power]]): 280・340・400
Voltage (V ): 3.6
Rated current (A): 0.8
Chuck capacity (mm): 6.35
Handle diameter (mm): 45

【Specification2】
Applicable bit: Width across flats 6.35mm
Charging port: USB Type-C
Charging time: Approximately 60 minutes
Number of charges: Approximately 500 times

【Material/Finish】
Body: PA6GF15+ elastomer, Bit: Special alloy steel

【Set contents/accessories】
Bit [[+]] 2x100mm 1 piece, charging cable 1 piece

【caution】
Please be sure to read the instruction manual.
When working with electricity, be careful of short circuits and electric shock.
Overloading may cause damage to the screws or injury.
When storing at home, be careful of children.